ES-COAT serie..
Transparent r..
Permeation ty..
EPOXY conduct..
roller applie..
Gravity-level..
Flowing sprea..
Troweling typ..
Reinforced ty..
Glass fiber b..
Special produ..
 
 
 
  Product show>> Product Category 1
 
点击查看正式图片
Product Name : Troweling type glass fiber based epoxy flooring
Show times: 2615
Click for the official picture
 
     Products Introduction

Troweling type glass fiber based epoxy flooring(1.5-5.5MM)

Features: employing different construction techniques on epoxy glass fiber toughened surface to increase the surface strength and toughness so as to improve the compression strength, wear resistance and corrosion resistance of the base.
Application scope: workshop floors with strict requirement of load-bearing and impact withstanding, but lower chemical concentration and light corrosion prevention.

Specifications and engineering methods

1、 Bare ground treating: clean and grind the new and old floor surface, remove the smoothened layer with hollowing, fill the surface pit and cavities, make sure no oil stain, coating or material easily adhesion to concrete on the surface.

2、 Primer construction: primer base and hardening agent are batched according to the ratio required and uniformly mixed, and applied uniformly on the treated floors with a roller or trowel.

3、 Conductive floating coat: batch the floating coat base and hardening agent according to the specified ratio, add a small amount of filling material and agitate the mixture uniformly; use a trowel to apply the mixture on the floor uniformly, trim the floor to the required evenness.

4、 Glass fiber construction: mix, according to the ratio required, and uniformly agitate resin base and hardening agent, and uniformly apply the mixture with a roller; pave the glass fiber on the ground surface already applied with intermediate coat, and compress the coat evenly and intensively with a roller(increasing applying times based on the specified thickness).

5、 Conductive floating coat: batch the floating coat base and hardening agent according to the specified ratio, add a small amount of filling material and agitate the mixture uniformly; use a trowel to apply the mixture on the floor uniformly, trim the floor to the required evenness.

6、 Top coat construction: mix top coat base and hardening agent according to the specified ratio and apply the mixture uniformly on the floor surface with a trowel.


[Notes:1、Customized design based on the client requirements.2、Slight variation of material proportioning based on different environmental temperature and bare ground moisture. Eversun Technical Department reserves the final interpretation right.]

 
 
 
COMPANY | NEWS | PRODUCT | TECHNICAL | PROJECT CASE | NETWORK | MESSAGES | CONTACT
Copyright:Eversun Synthetic Material (Kunshan) Co., Ltd.
Technology Support: Kunshan DLINE network Technology